FTLab GDK101 Gamma Radiation Sensor Module¶

The GDK101 sensor platform allows you to use your GDK101 sensor to monitor radiation levels at your place.

The GDK101 can measure average dose rate per 1 and 10 minutes, it also detect vibrations that can disturb the measurement.

The GDK101 requires setting up I²C for data communication.

Module Pins¶

Module Pin	Description
TX	UART TX pin
RX	UART RX pin
+5VIN	Positive supply voltage
GND1	Ground
SDA	I²C data bus
SCL	I²C clock bus
A0	Adress Jumper 1
A1	Adress Jumper 2

I2C Address	Jumpers State
0x18	A0 Short, A1 Short
0x19	A0 Open, A1 Short
0x1A	A0 Short, A1 Open
0x1B	A0 Open, A1 Open

../../_images/gdk101.jpg — GDK101 Gamma Radiation Sensor Module.¶

Component/Hub¶

# Example configuration entry
gdk101:
  i2c_id: bus_a
  address: 0x18
  update_interval: 10s

address (Optional, int): Manually specify the I²C address of the sensor. Defaults to 0x18 (A0 and A1 shorted). The address is made up using the state of A0 as bit 1 and the state of A1 as bit 2, so a total of four addresses is possible.
update_interval (Optional, int): Manually defined update iterval of sensor. Default to 60s.
i2c_id (Optional, string): Optional name of the bus.

Sensor¶

# Example configuration entry
sensor:
  - platform: gdk101
    radiation_dose_per_1m:
      name: "GDK101 Radiation Dose @ 1 min"
    radiation_dose_per_10m:
      name: "GDK101 Radiation Dose @ 10 min"
    status:
      name: "GDK101 Status"
    version:
      name: "GDK101 FW Version"
    measurement_duration:
      name: "GDK101 Measuring Time"

A sensor platform to radiation data

Configuration variables:

radiation_dose_per_1m (Required): Radiation average dose per 1 minute. All options from Sensor.
radiation_dose_per_10m (Required): Radiation average dose per 10 minutes. All options from Sensor.
version (Required): Fimware version of the module. All options from Sensor.
status (Optional): Sensor status. All options from Sensor.
measurement_duration (Optional): Total time of measurement. All options from Sensor.

Binary Sensor¶

# Example configuration entry
binary_sensor:
  - platform: gdk101
    vibrations:
      name: "GDK101 Vibrations"

Binary sensor that indicates if measurement was disturbed by vibrations.