TX20/TX23 Wind Speed/Direction Sensor¶
The tx20
sensor platform allows you to use your TX20/TX23
wind direction and speed sensors with ESPHome.
The only required pin is the black or brown cable (which is used to transmit data.)
The red cable should be connected to VCC (3.3V), green initiates the data transfer when connected to GND
and should therefore be directly connected to GND and the yellow cable should be always connected to ground.
The difference from the TX20 to the TX23 seems to be that the green cable does not matter any more and the
wind sensor is just sending a datagram every 2 seconds - pretty much the same as when the green cable was
connected to GND in the TX20.
# Example configuration entry
sensor:
- platform: tx20
wind_speed:
name: Wind speed
wind_direction_degrees:
name: Wind direction degrees
pin:
number: GPIOXX
Configuration variables:¶
wind_speed (Required): The information for the wind speed sensor. All options from Sensor.
wind_direction_degrees (Required): The information for the direction in degrees sensor. All options from Sensor.
pin (Required, Pin): The pin, where the black or brown cable are connected.
Note
In order to create a text sensor to show the textual representation of the wind direction the following config can be used. “tx20_id” needs to be replaced with the id of the TX20 sensor (not with the id of the subsensors).
text_sensor:
- platform: template
name: "Textual Representation Wind Direction"
lambda: |-
return {id(tx20_id).get_wind_cardinal_direction()};
update_interval: 2s
Note
It appears that the manufacturer discontinued production of this sensor, as it doesn’t seem to be available anymore for purchase. There are various alternatives though, and since ESPHome has a Modbus Component, any model supporting RS485 connection can be easily integrated.
Check out in the ESPHome Devices database example configurations for RS-FSJT-N01 Wind Speed and RS-FXJT-N01 Wind Direction sensors.